GENERAL PROPERTIES
PEEK is an abbreviation for PolyEtherEther-Ketone, a high performance engineering thermoplastic. PEEK grades offer chemical and water resistance similar to PPS (PolyPhenylene Sulfide), but can operate at higher temperatures. PEEK can be used continuously to 480°,F (250°,C) and in hot water or steam without permanent loss in physical properties. For hostile environments, PEEK is a high strength alternative to fluoropolymers. PEEK carries a V-0 flammability rating and exhibits very low smoke and toxic gas emission when exposed to flame. And unfilled PEEK is approved by the FDA for food contact applications (since 1998).
FEATURES •, Excellent chemical resistance •, Very low moisture absorption •, Inherently good wear and abrasion resistance •, Unaffected by continuous exposure to hot water or steam
PEEK GRADES
PEEK (Unfilled)
This general purpose grade is unreinforced and offers the highest elongation and toughness of all PEEK grades. Unfilled PEEK is available in sheet and rod forms in natural (a very light brown or tan) color (see photo above) and is also available in black. Black PEEK is ideal for instrument components where aesthetics are important, as well as for seal components where ductility and inertness are important. All unfilled PEEK grades comply with FDA regulation 21 CFR 177.2415 for repeated food contact.
PEEK (30% Glass Filled)
The addition of glass fibers significantly reduces the expansion rate and increases the flexural modulus of PEEK. This grade is ideal for structural applications that require improved strength, stiffness, or stability, especially at temperatures above 300°,F (150°,C). Glass-filled PEEK is light brown or tan in color.
PEEK (30% Carbon Filled)
The addition of carbon fibers enhances the compressive strength and stiffness of PEEK, and dramatically lowers its expansion rate. It offers designers optimum wear resistance and load carrying capability in a PEEK-based product. This grade provides 3½, times higher thermal conductivity than unreinforced PEEK -- dissipating heat from the bearing surface faster. Carbon-filled PEEK is black in color.
PEEK (Bearing Grade, Ketron HPV)
This grade of PEEK, containing carbon fiber reinforced with graphite and PTFE lubricants, offers the lowest coefficient of friction and the best machinability for all PEEK grades. Bearing grade PEEK has an excellent combination of low friction, low wear, high limiting PV, low mating part wear, and easy machining. Bearing grade PEEK is black or dark grey in color. See also these related products:
0 comments:
Post a Comment